Sikadur®-43 HS
Epoxy resin mortar
Sikadur®-43 HS is a 3 parts repair and filling mortar based on a combination of epoxy resins and selected high strength aggregates.
- Rapid hardening
- Shrinkage-free hardening
- High mechanical strengths
- Hardens even at high humidity
- High resistance against abrasion, impact and vibration
- Can be applied onto dry and damp substrates (no standing water)
Usage
Sikadur®-43 HS is a high strength material that is used as bedding or underfilling mortar (dry pack) or to repair horizontal concrete surfaces, such as:- Industrial floors
- Kerbstones
- Bridge bearings
- Foundation slabs
- Crane rails
- Joint arrises in highways
- Concrete runways
- Industrial floors
- Abrasion and impact resistance wearing layers
Advantages
Sikadur®-43 HS is an economical material with the following beneficial properties:- Rapid hardening
- Shrinkage-free hardening
- High mechanical strengths
- Hardens even at high humidity
- High resistance against abrasion, impact and vibration
- Can be applied onto dry and damp substrates (no standing water)
Packaging
22 kg sets (parts A + B + C)
Product Details
Shelf Life
12 months from the date of production, if stored in undamaged, original sealed packaging, and if storage conditions are met.
Storage Conditions
Sikadur®-43 HS shall be stored in cool and dry conditions, where it is protected from direct sunlight, rain and water.
Density
| Sikadur®-43 HS (parts A + B + C) | ~2.1 kg/l (mixed mortar) |
| Sikadur®-43 HS Primer (parts A + B) | ~1.05 kg/l |
Compressive Strength
| 7 days | ~95 N/mm² (at +25 °C, 65 % r.h.) |
Application
Mixing Ratio
| Sikadur®-43 HS part A : B : C | 2 : 1 : 30 parts by weight |
| Sikadur®-43 HS Primer part A : B | 2 : 1 parts by weight/volume |
Layer Thickness
Max. 50 mm / For large areas 15 mm
Ambient Air Temperature
+5 °C min. / +35 °C max.
Substrate Temperature
+5 °C min./ +35 °C max.
Pot Life
| Temperature | 10 kg | 2 kg |
| +40 °C | 30 minutes | 50 minutes |
| +30 °C | 45 minutes | 100 minutes |
| +20 °C | 60 minutes | 200 minutes |
SUBSTRATE QUALITY
All surfaces must be clean, free from oil, grease, old coatings, laitance, standing water and all loosely adhering particles. Sandblasting, high pressure water-jetting, grinding or scabbling of substrate is necessary.
SUBSTRATE PREPARATION
Prime with Sikadur®-43 HS Primer for dry substrate. On damp substrates (no standing water) use Sikadur®-31 CF as primer, work well into substrate. Always work wet-on-wet on the bonding bridge/primer.
MIXING
Mix all of Part B (hardener) with all of Part A (resin) for at least 2 minutes with a slow speed electric drill (maximum 500 rpm) until a smooth consistency and streakfree colour is achieved.
Then add all of Part C (aggregates) and continue mixing until a homogeneous mortar is obtained. Use immediately.
CLEANING OF TOOLS
Clean all tools and application equipment with Sika® Colma Cleaner immediately after use. Hardened or cured material can only be mechanically removed.