Sikacrete® Floor Level

6 months from date of production

Store properly in undamaged and unopened, original sealed packaging, in dry conditions. Protect from direct sunlight, rain and water.

~1.46 kg/l

Water : Sikacrete® Floor Level = 3.5 - 4.5 L : 25 kg bag

~2.17 kg/l

Note: By adding aggregates, the flow of Sikacrete® Floor Level may be reduced. It is recommended to carry-out site trials to determine the characteristics of Sikacrete® Floor Level (after addition of aggregates) meets the requirement of the project.

+5 °C min. / +35 °C max.

+5 °C min. / +35 °C max.

Priming

SikaLatex^® : cement (1 : 1 pbw) can be used to ensure sealing of the substrate to prevent the appearance of bubbles on the underlayment surface and improve the bond to the substrate. For more information please refer to SikaLatex^® Product Data Sheet or contact Sika's Technical Service Department.

~1.9 kg/m² per mm thickness

Only mix full bag. When mixing place the pre-measured clean water into a mixing vessel and gradually add the dry powder.

Mix thoroughly for a minimum of 3 minutes until a uniform and homogenous mix is achieved. Use a paddle attached to an electric stirrer (< 500 rpm).

Pump

Use a conventional floor screed dual-stage mixer and pump and control the water dosage to achieve the required flow. After placing onto the primed surface, use a pin rake to level the material to the required thickness. Then, use a spike roller to roll in two directions (perpendicular to each other) to remove entrapped air.

Manual

Pour the mixed material onto the primed surface and use a pin rake to level the material to the required thickness. Then, use a spike roller to roll in two directions (perpendicular to each other) to remove entrapped air.

Clean all tools and application equipment with water immediately after use. Hardened / cured material can only be mechanically removed.